Whether it's a leak, poor ventilation, or a space you want to finish off — we handle the full spectrum of attic work so your home stays dry and efficient.
Leak repair, ventilation upgrades, insulation — we do it all in one trip.
We trace the source of water intrusion and seal every entry point — flashing, sheathing, and underlayment as needed.
Soffit intake, ridge vent, or gable fans sized to your attic volume. Proper airflow protects the structure long-term.
If insulation got soaked or flattened we replace it with material matched to today's R-value standards for Oregon's climate zone.
Rotting fascia boards, deteriorated drip edge, and compromised rafters — all fixed before re-insulation begins.
Combination of proper ventilation and insulation at the eaves so snow melts away rather than refreezing under shingles.
Turn dead space into a den, office, or bedroom with structural reinforcement, drywall, and flooring.
An uninsulated or poorly ventilated attic is the single biggest drain on your furnace in Oregon winters. Fix the attic first before adding system capacity.
Even a small active leak will get worse with every rainstorm. It's always cheaper to fix it now than repair mold or rotted framing later.
Drops of water on underside of shingles means your attic has too much moisture from ventilation problems that need correcting today.
When sheathing or rafters have been wet long enough they lose structural strength. Call us immediately — this is not DIY territory.
Common questions about attic renovation and repair.
Stained or discolored sheathing, damp insulation, visible daylight through the roof deck, warped rafters, or water dripping during rain all point to active leaks that need immediate attention.
Yes. We handle structural reinforcement, insulation, drywall, and finishing — turning dead storage space into a finished bonus room.
Without proper intake and exhaust airflow, heat and moisture build up in the attic. That rots rafters from below, degrades insulation R-value, and can cause ice dams in winter.
That's exactly how we work — fix the root cause (leak/ventilation), then insulate to code. It saves you from paying twice for two separate service calls.
It's almost always worse than you think — let us climb up and tell you exactly what needs to happen.